Easy installation of your 3D sign
Wiring and connection of your advertising sign relate to an easy installation of your 3D sign that we provide are equipped with low voltage leds and transformer. In principle, each raised letter or component of your sign must be powered by a 12v cable and therefore connected to the transformer, 3 options are available to you:
- Connection of a sign by visible wiring on the front:
The electrical cables will be visible and are usually inserted in a protective sleeve or trunking. You have the possibility of bridging several elements in order to limit the number of cables on the front.
In this case we will tell you the group of letters or elements that can be connected together using a diagram.
- Connection of a sign from the inside:
Wiring and connection of your advertising sign concerns the power cables of the letters which pass through the wall towards the interior of the building and will connect to the transformer. If this solution is chosen, it will be necessary to drill the wall at the back of each letter in order to make the connection from inside the building.
We advise you to place the transformer in an accessible place, guaranteeing after-sales service in the event of a problem (false ceiling, hatch, sufficiently large spot hole)
- Connection of relief lettering on a panel or tablet sheet support:
The 220v power supply is waiting on your facade. By choosing the shelf sheet, the installation will be relatively simplified:
Attach the wall support frame
Connect your 220v cable to the transformer
Install the sheet on the frame and tighten the screws around it.
The letters are already connected by us and everything is tested before shipment, only one cable (220v) is to be connected to the transformer.
- Installation of raised lettering on rails:
The 220v power supply is waiting on your facade. By choosing to pre-install the lettering on mounting rails, installation will be relatively simplified.